Test Print
Last Updated: April 22, 2019Filament Diameter
Last Updated: April 22, 2019Setting up slicers
Last Updated: February 21, 2024Smoothie setup
Last Updated: April 22, 2019RRF Setup
Last Updated: April 22, 2019Marlin Setup
Last Updated: April 22, 2019G5 Installation
Last Updated: April 22, 2019G4 Installation
Last Updated: April 22, 2019G3 Installation
Last Updated: April 22, 2019G5 Assembly
Last Updated: April 22, 2019G4 Assembly
Last Updated: April 22, 2019G3 Assembly
Last Updated: April 22, 2019Printing the G5
Last Updated: April 22, 2019Printing the G4
Last Updated: April 22, 2019Printing the G3
Last Updated: July 17, 20195. Calibration and pre-flight
Last Updated: April 22, 20194. Firmware
Last Updated: February 5, 20243. Installation
Last Updated: April 22, 20191. Printing
Last Updated: July 25, 2019General rules for printing Flex3Drive parts. Download the required files from here. The files should be clean but good practice deems any stl’s for printing should be checked and repaired by a post processor such as nettfab. Released files will include inbuilt supports where required. Do not use the slicing software to autogenerate support, it...