Flex3Drive – Approved Ultimaker 2/2+/2go/2e

Rated 5.00 out of 5 based on 1 customer rating
(1 customer review)

£95.00 £83.00 Save 13%


  • Complete and assembled Flex3Drive for Ultimaker 2 range of machines (UM2 / UM2+ / UM2e / UM2go)
  • Quality Printed parts in Black ABS as standard – other colours available upon request (specify with order)
  • Graphite filled Teflon coupler (to 270c)
  • Flexible Driveshaft with driveshaft connector
  • Motor mount assembly secures the motor to rear of machine place of original feeder
  • Motor Cap
  • PTFE Tubing for driveshaft and filament guide (2mtrs)
  • PTFE Tubing Clips
  • Additional Screw based tension arm with bearing
  • Fastener Kit (including extended M3 screws for printhead attachment to lower hotend assembly)
  • Comes with precompiled .hex file to adjust settings for Flex3Drive parameters

(Note: Hotend not included – fits to existing original lower print head assembly and cooling fans)

Additional information

Weight 0.5 kg
Dimensions 25 × 20 × 6 cm

1 review for Flex3Drive – Approved Ultimaker 2/2+/2go/2e

  1. Rated 5 out of 5

    Ramonin3D (verified owner)

    I really like it! The Installation was pretty easy once I knew what to do and I didn’t even have to touch anything inside the firmware, because of the pre-compiled firmware that just works. I also found this to be really good for printing flexibles like NinjaFlex at reasonable speeds (40mm/s works really well for me), which I always found a bit difficult to do with the bowden system.

    At the time of writing this, I’ve been using it for a bit more than a week now, printing everyday (Mostly PETG) and also some long overnight prints and I have not had any problems with it.

Only logged in customers who have purchased this product may leave a review.