- Complete and assembled Flex3Drive for Ultimaker 2 range of machines (UM2 / UM2+ / UM2e / UM2go)
- Quality Printed parts in Black ABS as standard – other colours available upon request (specify with order)
- Graphite filled Teflon coupler (to 270c)
- Flexible Driveshaft with driveshaft connector
- Motor mount assembly secures the motor to rear of machine place of original feeder
- Motor Cap
- PTFE Tubing for driveshaft and filament guide (2mtrs)
- PTFE Tubing Clips
- Additional Screw based tension arm with bearing
- Fastener Kit (including extended M3 screws for printhead attachment to lower hotend assembly)
- Comes with precompiled .hex file to adjust settings for Flex3Drive parameters
(Note: Hotend not included – fits to existing original lower print head assembly and cooling fans)
Ramonin3D (verified owner) –
I really like it! The Installation was pretty easy once I knew what to do and I didn’t even have to touch anything inside the firmware, because of the pre-compiled firmware that just works. I also found this to be really good for printing flexibles like NinjaFlex at reasonable speeds (40mm/s works really well for me), which I always found a bit difficult to do with the bowden system.
At the time of writing this, I’ve been using it for a bit more than a week now, printing everyday (Mostly PETG) and also some long overnight prints and I have not had any problems with it.